SESSION: SISAMTuePM2-R6 |
Schultz International Symposium (8th Intl. Symp. on Science of Intelligent & Sustainable Advanced Ferromagnetic and Superconducting Magnets (SISAM)) |
Tue. 22 Oct. 2024 / Room: Knossos | |
Session Chairs: Hans Fecht; Student Monitors: TBA |
Magnetic wires have attracted considerable attention due to their rather attractive magnetic properties such as giant magneto-impedance (GMI) effect or magnetic bistability, potentially suitable for several prospective applications (magnetic and magnetoelastic sensors, magnetic memory and logic, electronic surveillance, etc.) [1,2]. Glass-coated magnetic microwires prepared using the Taylor-Ulitovsky technique with thin metallic nucleus (typically with diameters 0.1 to 100 μm) covered by flexible, insulating and biocompatible glass are therefore quite interesting for sensor applications [2]. This technique allows preparation of magnetic wires with amorphous or crystalline structure of metallic nucleus. In the case of glass-coated microwires the magnetoelastic anisotropy contribution becomes relevant since the preparation process involves not only the rapid quenching itself, but also simultaneous solidification of the metallic nucleus surrounded by non-magnetic glass-coating with rather different thermal expansion coefficients [3].
The purpose of this paper is present last results on tailoring of soft magnetic properties and GMI effect in glass-coated microwires paying special attention to achievement of high GMI effect and on optimization of domain wall dynamics.
The impact of post-processing on soft magnetic properties and the giant magnetoimpedance (GMI) effect of Fe- and Co-based glass-coated microwires is evaluated. A remarkable improvement of magnetic softness and GMI effect is observed in Fe-rich glass-coated microwires subjected to stress annealing. Annealed and stress-annealed Co-rich microwires present rectangular hysteresis loop and single and fast domain wall propagation. However, Co-based stress-annealed microwires present higher magnetoimpedance ratio. Observed stress-induced anisotropy and related changes of magnetic properties are discussed considering internal stresses relaxation and “back-stresses”. Consequently, stress annealing of ferromagnetic microwires allows achievement of interesting combination of magnetic properties.