ORALS
SESSION:
IronThuPM2-R8
| Usui International Symposium on Advanced Sustainable Iron and Steel Making (7th Intl. Symp. on Advanced Sustainable Iron and Steel Making) |
| Thu Oct, 24 2019 / Room: Ambrosia B (77/RF) | |
| Session Chairs: Moritoshi Mizutani; Shunsuke Hori; Session Monitor: TBA |
15:55: [IronThuPM209]
Heat Loss Control in Stave Cooled Blast Furnace by Optimizing Gas Flow Pattern through Burden Distribution Basant
Kumar Singh
1 ; Bhaskar
Ramdasu
1 ;
Padma
Pal1 ; Dhiren
Patnaik
2 ; G.s.r. Murthy
.
3 ; Vishwakarma
Raj Kumar
3 ; Kumar Lal
Santosh
3 ; Jaya Krishna
P.
3 ;
1Tata Steel, Jamshedpur, India;
2Tata Steel Ltd., JAMSHEDPUR, India;
3Tata Steel Ltd., Jamshedpur, India;
Paper Id: 220
[Abstract] The productivity of Blast Furnaces is largely impacted by fuel efficiency. Control of heat loss is one of the enabling parameters for achieving lower fuel rate. I-Blast Furnace is the latest and largest Blast Furnace of Tata Steel Jamshedpur with a working volume of 3230m<sup>3</sup> and with rated capacity of 3.055 million tons per annum. Optimizing heat losses in Belly and Bosh zones remains a major challenge for blast furnace operators.
The I-Blast furnace has installed Cast Iron & Copper Staves cooling members where copper staves are installed in Belly, Bosh & Lower Stack, whereas cast iron staves are installed in the upper stack area. Stave cooled Blast Furnaces are prone to higher heat losses in the Belly and Bosh regions with increase in coal injection rate as Bosh gas volume increases. Under these conditions, managing gas flow patterns through proper burden distribution, casting techniques, and maintenance of desired raw material qualities are of upmost importance for sustaining high injection rates. This study details the burden distribution control by the Ore & Coke ratio adjustment at the wall and center of the Blast Furnace as the coal injection rates increase from 140 kg/thm to 220 kg/thm. Control of blowing parameters, casting philosophy, specification for raw materials, and division of operational practices for controlling heat losses is also elaborated with the model that is used to visualize heat loss patterns in different zones of the Blast Furnace.
References:
1. Principles of blast furnace ironmaking: Theory and practice: A. K Biswas\n2. An Introduction to Modern Iron Making" by R. H. Tupkary and V. R. Tupkary
